Altec 9440A power amp BIAS set help

[MerlinVSM]

I have replaced the most of the electrolytic caps in the amp and I am not sure how to set the bias. The manual
"insert a clamp-on dc milimeter over BLUE-wire from terminal E21 of channel 1 output circuit board and set bias adjustment pot R22 to 75+-5mA".

How to interpretate to "insert over BLUE-wire" ? Where to connect the to dc millimeters cables?

The BLUE-wire run from output circuit board terminal E22 to 9800uF/100V power capacitor.

Is it just to connect the milliamperemeter at E22 on the output board and at the power capacitor screw terminal ?

Thanks for help

[gvasale]

What they're trying to tell you is that by using a clamp on meter you dont have to unsolder the connections to insert the old time ammeter in series with the point to point wiring.

This You Tube clip may help you understand: How-To use a clamp-on ammeter - YouTube

Hope this helps...

[MerlinVSM]

Thanks for help.

BR
Lars

[tomt]

this one?